South Korean injection molder Taesung Precision Co. Ltd. will build the first plant in the United States - and its first plant to produce automotive parts - and the new plant will be located in Shorter, Alabama. Alabama’s Department of Commerce issued a press release on December 6, 2013, stating that a new plant costing US$6.6 million and occupying an area of ​​40,000 square feet will employ 70 employees during its initial phase of operation. Taesung, headquartered in Gimhae, South Korea, has factories in South Korea, Poland, Russia and Mexico to produce parts for consumer goods. Its customers include LG Electronics, Whirlpool and Electrolux. The Shorter plant enabled the company to be close to Hyundai Motor's assembly plant in Montgomery, Alabama, to facilitate the opening up of the automotive industry's supply base. State government officials stated that in addition to producing molded parts, Taesung will also begin to provide design services for automotive customers. The plant is expected to be fully operational by the end of 2015, and the annual payroll will be $2.8 million. Officials in Alabama stated that they expect Taesung to expand the plant in the future, but the company did not disclose any detailed plans. SZL series chain grate boiler Biomass Steam Boiler,Industrial Biomass Steam Boiler,Chain Grate Biomass Boiler,Chain Grate Biomass Steam Boiler,Automatic Biomass Boiler Henan Yuanda Boiler Co., Ltd. , https://www.steams-boiler.com
Our company SZL type boiler is a double-drum water tube assembly chain grate boiler. The boiler proper has an upper drum and a bottom drum longitudinally arranged along the boiler center. The front of the upper drum and two sides water wall tubes constitute the boiler hearth radiation heating surface, and the tubes between the rear of the upper drum and the bottom drum constitute the convection heating surface. The economizer is arranged on the rear of the boiler,part of heat from high temperature exhaust gas generated by burning was absorbed by economizer, then the exhaust gas go through the cooling chamber,exhaust gas enters the convection heating surface to transfer heat power again, and through economizer,dust collector, finally draught by ID fan to Chimney,discharges into the atmosphere.
Core Technology:
1. Longitudinally arranged double drum
2. Airtight and uniform-pressure wind room
3. Customized combustion device
4. "α" type flame combustion
5. High quality aluminum silicate insulation
6. Built-in dust cleaning
7. Easy operation control system
South Korean molders will build new plant parts in the United States