Electrostatic Separator,Electrostatic Separation Machine,Electrostatic Separation Equipment,Electrostatic Separator For Sale Xinxiang Traceability Environmental Protection Equipment Co., Ltd. , https://www.syrecycle.com
Monorail energy-saving trolley line is a commonly used type of trolley line. In the use of some of the faults are relatively frequent, and today manufacturers will give you a summary.
The more common faults of the trolley wire are as follows:
One kind of monorail energy-saving type trolley wire is a kind of power-off line. The original analysis of this failure analysis is as follows:
1. The brush is climbing in the conductor;
2, brush wear is serious, can not touch the conductor;
3, conductor joints are not even;
4, the use of a single collector;
5, loose rail joints.
For these possible factors, it is necessary to check the collector brushes and replace them, and then readjust the connection nodes and tighten the connection screws.
The other is that when the trolley line is in working condition, there is a large amount of shaking, and the possibility of this phenomenon is three. On the one hand, it may be that the fork cannot absorb the transmission error; on the other hand, it may be because The straightness of the guide rail is poor; it is also caused by the looseness of the lifting rack that may be the trolley line. The processing method is very simple. First, correct the tractor so that it can freely absorb the transmission error; then adjust the straightness of the guide; tighten the pylon screw in the final step.
Of course, the failure of the trolley line is far more than the above-mentioned two, but it can be seen that as long as the analysis of the reasons, taking appropriate measures can be resolved. Hydraulic pressure rail manufacturers introduce windproof effects.
Analysis of Common Failures of Monorail Energy-saving Type Sliding Lines
Analysis of common failures of single rail energy-saving trolley wires: