Generally, no matter how long the car is bought, the car will be regularly maintained, and the maintenance must not be filmed. For the film, you may not know that opening the window after the car film will affect the effect of the film. Everyone should pay attention to this later. However, some masters will remind you when you are in the repair shop. Today, Xiaobian will tell you what will happen when you open the window after the car is filmed . High-quality car film usually has good wear resistance. The special high-performance resin glue is used between the film layers. The adhesion is very outstanding. When the film is applied, the edge of the film and the edge of the glass are only 2 mm. Moreover, the anti-scratch coating makes it highly scratch-resistant and has a long life and is easy to maintain. On weekdays, the lift window is also easy to wear the film surface. Inferior film will be scratched after one or two months. Choosing a good quality film can avoid this situation. 1. How long does it take to open the window after the car is filmed? After the construction of the car foil, do not lift the window at will within 3 days in the summer and 7 days in the winter. The reason is that the glass has just been attached to the car film. The glass is usually tight. During the opening and closing of the window, the edge of the car film is easy to roll up and cause damage to the car film. After the car is finished with the film, it is within 3 days in the summer and less than 7 days in the winter. Do not lift the window at will. The main reason is that the car has just been attached to the automobile film. The glass is usually tight. During the opening and closing of the window, the edge of the car film is easy to be rolled up and curled, causing certain damage to the car film. 2. Precautions after car filming Within one week after car filming, when parking the vehicle, you should choose a sunny place to ensure that the water vapor in the car film is fully evaporated; it is strictly forbidden to wash the car within three days of the car film. This is to prevent the car film from falling off due to moisture, so When the car film is applied, the car can be washed and then filmed. The micro-water filming process of Weigu Auto Film can better ensure the effect of automobile film construction in addition to protecting the circuit panel of the car. 3. Cloudy water vapor appears after the car is filmed Due to weather and other reasons, the time required for the car to dry out after filming is different: in winter and rainy days, cloud-like water and gas may appear between the film surface and the glass, which is a normal phenomenon. After 4-10 weeks by the sun, it is natural. Dry out and disappear. 4, there are stains on the car foil If there is stain on the car foil, do not scratch it with a sharp hard object or use a irritating chemical solution. It is recommended to wipe it gently with a soft towel such as a clean wet towel, sponge or soft cloth. At the same time, avoid using corrosive chemical solvents when washing your car to avoid damage to the surface of the car foil. 5, can open the air conditioner after the car film After the front bumper film is applied, do not let the air conditioner blow forward directly in the 7 days. After the film is stuck in the rear gear, do not open the rear fogging line within one week. If the moisture is not dry, it will easily affect the defogging line. Be sure to turn off the wire after use to avoid the long-term high temperature causing the car foil to foam and deform. 6, how long after the car film can be sucked with a suction cup In order to ensure that the car film adheres firmly to the glass, do not directly affix or hang things on the window within two months after the car film is applied, so as not to open the gap when pulling up the suction cup and the sticker, or damage the car film. After the car film is opened, how will it be finished for everyone? The correct use can increase the life of the film, and it will not be scraped up just after it is finished. Still have to post. Under normal circumstances, everyone can pay attention to their own after filming. There are also notes on Xiaobian that everyone should pay attention to. I hope that the culture of Xiaobian is useful to everyone.
Hand lever block :
Lever block is used for fixing the loads. For example, Fixing the goods on the truck or rear plate welding which is JIG.
Alike chain block, lifting is possible but, it would lead to very less effective work. Only fixing purpose of use is recommendable.
Features
Structure designed a load dispersal
Products show
Our Services
1.Client
We treasure and try to understand all the different needs of our clients and seek to forge a long term professional relationship with them. The satisfaction of each and
every customer is our main goal and motivation in conducting our business.
2. People
We work as a team and treat each other with respect. Our solid, capable and knowledgeable team is valued as the greatest asset and an integral part of the business.
3. Product
Our products are of high quality standards and always come with certificate of compliance by the manufacturers.
4. Performance
We aim to achieve high level of performance and satisfaction to both our client and people, which include delivering high quality services and treating people with integrity.
5. Free sample and OEM service
We can provide free samples to you and we also have OEM service, we can put your
logo on the label and the information you need on the webbing too.
Lever Hoist,1.5Ton Lever Block,Lever Lift Hoist,Hand Lever Block Hebei Liston Lifting Rigging Manufacturing Co., Ltd. , https://www.liftingriggingfactory.com
- Strong riveted body
- Smooth operation with lever due high deceleration
- Device to soften impulsive load
- Handy usage with short lever in small space
- Control of chain by authomatic brake without GRIP RING .
What will happen when the car is filmed?